| Subject | Text |
| Hi madmatt2024, how are you doing?
I am back again. wow! you've give me a nice picture illustrat |
| Monitor philips 107s pincushion distortion | Hi :wink:
First of all, sorry for my english, i'm a french guy :lol:
My CRT monitor Philips |
|
|
| please give the details of problem .
check the interface cable and all the diodes on the CRT pcb . |
| Absolutley Atom,
But I think knowing How much A User knows about electronics would allow the engin |
| Well I finally was able to do the repair on this set. I ordered the wrong caps at first. I ordered t |
| I turn it down but any seconds after this lines appear and picture go to
bad colour and flicking a |
| TV PANASONIC TC-2195 DRS | Help! Veri low britness & contrast like a old CRT. I need a circuit diagram. |
| hi BobC,
how old is your monitor? you didn't give any info about your monitor. if your familiar wi |
| TV zenith Sj2765S5 | :?: I am looking for the service manual or datasheet for a crt TV Zenith SJ2765S5. Thank's. |
| Your dead TX100 chassis Tv | As well as the good advice given by last poster, check/replace the Polyester/Mylar Capacitors across |
| fast help pls | I need service mode code for TV WATSON FA7040
/11AK19E3/
e-mail [email protected] |
| Flat Screen | It is a CRT screen that is perfectly flat. If you would like to own one, check out www.FreeFlatScre |
| A CRT (picture tube) have 3 electron guns,each with their own filament, (heater) so you should see a |
| Sony KPR-36XBR | Just bought this at a sale. Brought home, set came on but had contaminated green crt fluid. Changed |
| Maybe this wire plugs onto the CRT board on the back of the tube? |
| If HV stays on check CRT for weak emision. This will cause sony TV's to blank out the video. |
| Viewpoint | Hi everybody!
Do You know anybody where I find service manuals for
CRT monitor Viewpoint VP2110VB |
|
|
| National Model TC-2186 MR -Display powers off after 10 mins | This TV has been operating problem free up to end 2004 (purchased 1991).
Has developed this probl |
| Look on the crt sockets. |
| maybe i am getting hosed? | Hi Larry -
They would charge me $369.50 for labor, and $80,00 for parts.
It was an in-home visit |
| Can't adjust red convergence APEX projection TV | I'm working on an APEX model GB5108 rear projection television. The red picture is pinched slightly |
| Bright | There is a black transformerwith a red wire coming out of the top and attached to the back of the CR |
| re; too bright | Hi, try turning the "screen control" counter clockwise a little, I
don`t work on monitors so I`m no |
| 6 LED FLASHES CRT FAULTY.
6 LED FLASHES FIELD CHIP PINS.
check the soldering of the field chip at |
| I think you misunderstood me about the plug. The plug I was takling about is at the rear of the CRT |
| Could be a bad CRT. Have you tried uplugging CRT board? If power remains on, there's your problem. U |
| Sony CPD-100VS Service Manual | Hello! I am looking for the service manual for the sony monitor CPD-100VS. Even the parts list wou |
| SCHEMATICS FOR SDP4575 PIONEER | THE PROBLEM WITH THIS TV IS THAT IT HAS DOUBLE VISION ON THE BOTTOM 1/2 OF THE SCREEN. THE TOP LOOKS |
| flyback line | its possible that flyback lines that appears after 3 minutes generate by
crt own.
i didnt find an |
| It is demagnetize --not demagnify. Any TV servicer with a degauser coil can do that. In general ever |